Differences

This shows you the differences between two versions of the page.

--- bachin_d8-cnc2418 [2018/09/28 18:00]
ljx
+++ bachin_d8-cnc2418 [2019/01/28 11:38] (current)
ljx
@@ Line 35: / Line 35: @@
 Candle is a portable software that does not need to be installed.
 Double click the Candle.exe to start.
-If you are using the MAC system, click Candle.dmg instead.
+If you are using the MAC system, click Candle.dmg instead. Learn more about [[candle|Candle]]
 {{:p4.png?600|}}
@@ Line 81: / Line 81: @@
 Install Probe tool.
 Refer to the board connection picture for more information.
+{{:p11.png?600|}}
+Click the Probe Button>>{{:p12.png?100|}}
+The Z Axis will go down, reach the Probe Tool surface, stop, go up, stop finally. The Z axis height value will be adjust right when stop finally. Remove the Probe Tool.
+**Tip:** Do not Zero Z Coordinate after finished a Probing operation.
+**Unlock**>> {{:p13.png?100|}}
+The machine will go into Alarm State if something wrong happened. For example, the machine reach the limit switch when working.
+Exclude errors, click Unlock button to continue.
+**6. Start Engraving**
+Usually the engraving process is as bellow.
+Make a G-Code file  >> Power the Machine >> Run Candle  >> Load the G-Code File>>Place the Engraving Object >> Move to start point and Zero X&Y Coordinates >> Probe >> Start Engraving.
+We provide some examples to help you quickly familiarize yourself with the machine.
+Click Open, select a G-Code file in the Example G-Code file folder.
+{{:p14.png?600|}}
+After G-Code is loaded.  According to the above description Place the engraving object,  move to start point and zero X&Y Coordinates,  probe , finally click Send button to start engraving.
+{{:p15.png?600|}}
+**Pause & Stop Control**
+Click// Pause// to pause, Click Pause again to Continue. Click// Abort// to Stop.
+{{:p16.png?600|}}