✎ pen_up_pen_down_problems [Bachinmaker]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== PEN UP & PEN DOWN PROBLEMS ======

Problems that may occur during use, such as “PENS UP”& “PENS DOWN” not working.

First check if the swing arm is at the correct angle：

{{:a0副本.jpg?600|}}

Now let's adjust the arm to the right angle:

1\Use a small screwdriver to remove the swing arm:

{{:a2副本.jpg?600|}}

2\Click on PEN UP of the software:

{{:a.png?600|}}

3\Install the swing arm follow the image:

{{:a3.jpg?600|}}

inside：

{{:a4副本.jpg?600|}}

{{:a5副本.jpg?600|}}

4\ Then click on PEN DOWN of the software:

{{:aaaa3.png?600|}}

5\This is the correct angle of the swing arm:

{{:a6副本.jpg?600|}}

{{:a7副本.jpg?600|}}

DONE!!

If not the angle problem ,the software is connected success, then PEN UP & PEN DOWN not working ,maybe the servo was broken, just change a new one.