The Engraver Master was successfully upgraded recently,the engraving speed faster than before。
Download Engraver Master:
http://www.bachinmaker.com/update/litefire/setup.exe
Directly to generate the tool path and no need to trans-code. The engraving speed and the laser power is adjustable. There are more function like :change the size of the picture, enter text, import the NC file or dxf file. The file format that can be imported is:jpg,jpeg,png,dxf,g-code(NC file),and so on.
Here are the user guide for Engraver Master:
step 1. Installation
After installed, you will find an icon Named Engraver Master on computer desktop and the Start Menu. Double click the icon to start :
step 2. Software connected Interface of the Engraver Master:
Connection succeeded:
Connection failed:
Reasons for failure to connect:
1>If connection failed ,check the Device Manager of computer,find USB-SERIAL CH340 Port Device.
If there is an exclamation point on the device,it means the installation failed .
you should delete the icon ,and install again. Sometimes the software install succeeded but
can not connected to the machine , restart the computer.
2>The installation is no problem,but can not connect the machine, you should check the USB cable
or your USB port of the computer, change a USB cable or change a USB port.
3>Exclude the above reasons,Check the NANO which is on the control board
(the blue module connected to the USB cable) ,when there is a small light kept flashing,
maybe the firmware was missing,update the firmware as follow:
4>If the firmware is update and still can not connected , basically, it can be judged
that NANO has been damaged. Change a new one.
NC Sender is the most common mode of engraving,it can satisfy most of the engraving needs,fast and Very good effect.
Here are the details.
Load NC file: load NC file (g-code file);
load CAD DXF filetips: Some versions of the file are not compatible, When you save DXF files,
select version: AutoCAD 2000, and the unit is mm).
Start /speed: Repeats(Repeated several times when used for cutting);
Speed(to adjust the speed); test size: test the size before start,for positioning).
Create image Nc file: load picture from computer,adjust the details and size.
Select the mode that you like. Look at the difference:
Create text Nc file: enter the text and select one of the font ,setting the char height
and line height, then create. Outline is just like the cutting mode .
step 1.Load a picture :
step 2.Next:
Step 3.Set the size:46,click on ‘OK’.
Device Setting Tips: Different laser module requirements of different device settings.
the speed of 500mw laser should set :900-1500,and 1000-1600mw set 1200-2000, 2500-5500mw set 1600-3000.
If you want to cut something , the speed should setting more slower.
when the settings' done, click on Test the Size and Start.
DONE!!
about how to create an NC file ,tutorial: http://bachinmaker.com/wiki/doku.php?id=create_nc_file
Device Setting Tips: Different laser module requirements of different device settings.
the speed of 500mw laser should set :900-1500,and 1000-1600mw set 1200-2000, 2500-5500mw set 1600-3000.
If you want to cut something , the speed should setting more slower.
when the settings' done, click on Test the Size and Start.
Support Information:
e-mail:support@bachinmaker.com