✎ bachin_d8-cnc2418 [Bachinmaker]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
**Bachin D8-CNC2418 » Relevant information » User Guide**

**0.Overview**

Shipment of parts, need to assemble the machine by yourself. Please watch the [[assembly video]] and **instruction manual** before starting assembly.

{{:img_3354详.jpg?600|}}{{:img_3355详.jpg?600|}}
{{:img_3373详.jpg?600|}}{{:img_3400详.jpg?600|}}

**1.Connected the cables:**

Connected all the cables as follow:

{{:2418xyz_axis.jpg?600|}}
{{:2418-control_board1.jpg?600|}}

**2.Install driver**

Find the driver from the USB flash driver,or download from here : http://www.bachinmaker.com/down/candle.zip 
Double click the CH340.EXE in the Driver folder.
If you are using an MAC computer, click the CH34x_Install_V1.4.pkg in Driver/MAC folder.

{{:p1.png?600|}}

Click INSTALL：

{{:p2.png?600|}}

Wait until success：

{{:p3.png?600|}}

**3. Software connected**

Candle is a portable software that does not need to be installed.
Double click the Candle.exe to start.
If you are using the MAC system, click Candle.dmg instead.

{{:p4.png?600|}}

An Idle Status should be displayed on Candle interface：

{{:p5.png?600|}}

//If  not//, please:

1, Check if the USB wire is connected correctly.
2,Open DEVICE MANAGER ,check if a device named CH340 is connected under the Ports(Com & PLT).  See what state the device is.
State Normal like this:

{{:p6.png?600|}}

Driver no installed:

{{:p7.png?600|}}

In this case, please try install the driver again, otherwise, please contact us and attach a circuit board photo and device manager screenshot.

**4. Run the software -- Candle** Watch the video firstly: https://www.youtube.com/watch?v=IObj8f6JOCM

Zero the Work Coordinates.

{{:p8.png?600|}}

We usually Zero the Work Coordinates after Moving a Axis .

{{:p9.png?400|}}

**Homing**{{:p10.png?100|}}

Homing make machine go to the same start position for a Repeated Engraving. Only when a machine come with a XY limit switch, homing is available.
Click the homing button, the engraving machine will move XY axes until reach the limit switch.
After a homing, X&Y coordinates is set to (0,0).

{{:w.jpg?100|}}Warning: please stay away from the engraving machine when the machine is homing.

**5. Z Axis Probing**

We must adjust the Z Axis height value before engraving. The simple way is move z axis, let the engraving knife just above the engraving level, then Zero the Z Coordinate. The quick way is using a Probe tool.

Install Probe tool.
Refer to the board connection picture for more information.