Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
install_end_stop_switch_laser_machine [2019/04/22 11:52] ljx |
install_end_stop_switch_laser_machine [2019/04/22 12:04] (current) ljx |
||
---|---|---|---|
Line 28: | Line 28: | ||
Need to enable the limit switch on the software. | Need to enable the limit switch on the software. | ||
+ | If you are using BachinDraw as the Engrave Software. | ||
+ | {{:enable_limit_bd.png?nolink|}} | ||
+ | |||
+ | Or using Engraver Master | ||
+ | |||
+ | {{:enable_limit_em.png?nolink|}} | ||