Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
install_end_stop_switch_laser_machine [2019/04/22 11:37] ljx |
install_end_stop_switch_laser_machine [2019/04/22 12:04] (current) ljx |
||
---|---|---|---|
Line 8: | Line 8: | ||
You can install two or four limit switches. | You can install two or four limit switches. | ||
+ | |||
+ | When installing two, install two limit switches in the minimum direction of the XY axis. | ||
When installing four, two on the same axis need to be paralleled. | When installing four, two on the same axis need to be paralleled. | ||
+ | One is installed in the minimum direction and the other is installed in the maximum direction. | ||
Line 23: | Line 25: | ||
{{:p90422-112320.jpg?nolink|}} | {{:p90422-112320.jpg?nolink|}} | ||
+ | |||
+ | Need to enable the limit switch on the software. | ||
+ | |||
+ | If you are using BachinDraw as the Engrave Software. | ||
+ | |||
+ | {{:enable_limit_bd.png?nolink|}} | ||
+ | |||
+ | Or using Engraver Master | ||
+ | |||
+ | {{:enable_limit_em.png?nolink|}} | ||